Papers in JOURNAL OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
(vol.46 no.538 November 2005)
Acoustic Emission Characteristics on Variation of Cutter Tip Thickness during Cutter Indentation on Paperboard
Shigekazu SUZUKI, Yasushi FUKUZAWA, Shigeru NAGASAWA, Isamu KATAYAMA and Hajime IIJIMA
(Received on September 3, 2004)
Forming and Strengthening of Clad Cup Wall by Utilizing the Buckling Phenomenon
Nobukazu HAYASHI and Masanori KOBAYASHI
(Received on September 6, 2004)
Profile Effect of Round-Edge Cutter on Shear Characteristic of Paperboard Cutter Indentation
Shigeru NAGASAWA, Satoshi HOSOYA, Satoshi NAGAE
(Received on September 6, 2004)
Numerical Analysis of Strain Distribution in Rolled Plates Introduced by Cross Roll Rolling
- Study on Creation of Shape and Properties for Shear-Added Rolling Plates ‡U -
- Study on Creation of Shape and Properties for Shear-Added Rolling Plates ‡U -
Tadanoby INOUE and Kotobu NAGAI
(Received on September 16, 2004)
Effect of Ironing Conditions on Surface Roughness of Both-Sides-Ironed Cans
- A Research of Both-Sides Ironing Process ‡T-
- A Research of Both-Sides Ironing Process ‡T-
Takayuki AOKI, Kunio MIYAUCHI, Mitsuhiko NISHIMURA and Kazuhiko NAKAMURA
(Received on December 2, 2004)
Flexible Small-Angle Bending of High-Strength Sheet Metals by Shear Deformation with Negative Punch-Die Clearance
Kenji HIROTA and Yorifumi MORI
(Received on December 7, 2004)
Development of Alternate Pipe Bending Method for Heat Exchangers
Toshiyuki AMINOTO, Keiichi NAKAMURA, Tsuyoshi KUBOTA and Hiroya MURAKAMI
(Received on December 16, 2004)
 Copyright (C)1997- 2005 JSTP. All Rights Reserved. |
|