Papers in JOURNAL OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
(vol.49 no.567 April 2008)
Effects of Miniaturization of Surface Cavities and Surface Roughness of Workpiece
\Microforming of Surface Cavities as Direct Marking of Two-Dimensional Bar Code Symbols Using Dot Impact Pin II\
\Microforming of Surface Cavities as Direct Marking of Two-Dimensional Bar Code Symbols Using Dot Impact Pin II\
Hiroshi IKE
(Received on February 13, 2007)
Influences of Punch Length and Blankholder on Clearance Compensation Effect in Fine Precision Shearing
Masahiro SASADA and Isamu AOKI
(Received on March 8, 2007)
Improvement of Formability by Wrinkling Control in Hydroforming of Tubes
Ken-ichiro MORI, Kentaro HAYASHI, Mohsen LOH-MOUSAVI and Tomoyoshi MAENO
(Received on April 5, 2007)
Development of Plastic Joining Method Using Indentation
Shinji HANAMI, Ryo MATSUMOTO, Kozo OSAKADA and Hyoji YOSHIMURA
(Received on June 18, 2007)
Effect of Press Forming Conditions on Shape Fixability of Hot Stamped Hat-type Parts
Takehide SENUMA, Hideaki MAGOME, Akihiro TANABE and Yoshito TAKEMOTO
(Received on July 20, 2007)
 Copyright (C)1997- 2007 JSTP. All Rights Reserved. |
|