|
JOURNAL OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
vol.62 no.724 May 2021
---CONTENTS---
Regular Papers
Development of In-plane Biaxial Compression Test Method for Thin Sheet and Investigation of SD Effect under Biaxial Stress Condition
―Deformation Behavior of Different Types of 980 MPa Grade Steel Sheets―
……Yuki OGIHARA, Toru MINOTE, Akinobu ISHIWATARI and Yoshikiyo TAMAI 1（55）
Feasibility of Mass Production Verified by Cut Surface Quality and Tool
Load in Negative Clearance Blanking
……Yohei SUZUKI, Ming YANG and Masao MURAKAWA 7（61）
BULLETIN OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
vol.4 no.41 May 2021
Mini Special Issue on Lastest Technology for Die Life Extension
---CONTENTS---
Essay
Procedures of Technology Development to Improve Tool Life
……Tamotsu NAKAMURA 1（275）
Reviews
Lates Trend in Hard Coating Technology
―Focusing on Development of Ultra-High-Speed Coating―
……Hiroyuki KOUSAKA 3（277）
About Surface Modification by WPC and PIP Treatment and Extension of Mold
Life
……Yuuta AKAO 8（282）
Microshot Peening
……Yasunori HARADA 12（286）
Advanced Technologies for Die Materials and Manufacturing
……Tatuhiko AIZAWA 17（291）
Tool Life in Punching Process
……Tomomi SHIRATORI 23（297）
Die Wear and Life Prediction Technology of Hot and Warm Forging
……Takuma OKAJIMA 27（301）
Improvement of Die Life for Cold Forging
……Eisuke MURAI and Daiki MORITA 32（306）
Process Visualization Technology for Improvement of Die Life
……Ming YANG 37（311）
Introduction on Simulation of Metal Forming
Modeling of Anisotropic Material
……Tomoyuki HAKOYAMA and Nobuyasu NOMA 42（316）
Reports
Implementation Report on Student Research Meeting of JSTP Young Research Members at Three Kanto Branches
……Shohei KAJIKAWA 48（322）
Copyright (C)1997-2021 JSTP. All Rights Reserved.
|