|
JOURNAL OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
vol.65 no.765 October 2024
---CONTENTS---
Regular Papers
Bake Hardening Behavior and Plastic-strain-dependent Elastic Modulus of
Steel Sheets for Automotive Outer Panels
……Shota KUSAKA, Takashi IWAMA, Kentaro SATO, Yoshikiyo TAMAI and Fusahito YOSHIDA 1（139）
Mechanism of Generating Defects at Die Edge in Sequential Press Forming
……Naoya HIRANO, Tsuyoshi KIMURA and Takayuki HAMA 8（146）
BULLETIN OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
vol.7 no.82 October 2024
---CONTENTS---
Mini Special Issue on Latest Trends of Numerical Simulation Technology in Metal Forming and Press Dies
Essay
Changing Bad Stress to Good One by Science and Technology
……Ninshu MA 1（623）
Reviews
Topology Optimization for Cooling Channels in Molds
……Kentaro YAJI 3（625）
Development of Rapid Heating and Cooling （H&C） Molds for Forming Thermoplastic
Composites Applied Metal Additive Manufacturing Technology
……Masachika YAMANE and Shuichi TANOUE 8（630）
Technology of Press Forming Simulation for High Strength Material
……Atsushi YOKOI 14（636）
Computational Analysis in Impulsive Materials Processing
……Masatoshi NISHI 18（640）
Simulation Technology for Sheet Metal Forming and Tube Forming
……Takaki OGAWA 23（645）
Reports
Report on the 1st Study Tour of the Laser Processing Committee
……Yoshihiro SAGISAKA 27（649）
Interview
High Value-Added Products Created by the Forte of Cold Pressing
―On-Site of Technical and Proposal Capabilities of Pacific Industrial Co., LTD.―
……29（651）
Copyright (C)1997-2024 JSTP. All Rights Reserved.
|